Name/Ime -Blaupunkt
Model - 5 disc multipl choice
Sec.Type/Tip kodiranja -
Partnumber - BP915014245855
Manuf./Proizvođač -
MCU/Procesor -
EEPROM -
Sec.loc./Zaključan u ? -
PA/Audio izlaz -
Serial No/Serijski broj -bp915014245855
Utisnute oznake na limu -
Potreban code - da
Opis kvara i opis poduzetih radnji i merenja na aparatu :
Cd sarzer je iz Fiat Punta, Na automobilu je zamenjen racunar,i od tada na radiju nedozvoljava upis koda cd
sarzera. Radio je kasetas,zaboravih da vidim kod stranke,koji model tacno. Radio radi normalno,ali sarzer nema funkciju,odnosno ne dozvoljava radio upis koda
Blaunpukt Cd Sarzer. kod ?
-
- Expert
- Postovi: 558
- Pridružen/a: 31 lis 2013 22:04
- Lokacija: skopje
sacekaj mozda unesen pogresan
-
- Stariji član
- Postovi: 67
- Pridružen/a: 30 lis 2016 16:10
Fiat algo!!!!
*223
The code is entered by using the buttons on the head unit that it is plugged into.
Please note that code entry is only possible after the code for the stereo has been entered first. If the unit may is codelocked it will need to be left switched on up for up to two hours to reset before another code entry attempt is possible.
Code Entry as Follows:
If Required, Enter Code in Head Unit First.
Press And Hold " CD.C" Button
The Display Shows "CD Player" Then "0000"
Press preset " 1 " repeatedly for 1st Digit
Press preset " 2 " repeatedly for 2nd Digit
Press preset " 3 " repeatedly for 3rd Digit
Press preset " 4 " repeatedly for 4th Digit
If the correct code number is now shown
Press Tuning Up Button " ^ " To Enter
*223
The code is entered by using the buttons on the head unit that it is plugged into.
Please note that code entry is only possible after the code for the stereo has been entered first. If the unit may is codelocked it will need to be left switched on up for up to two hours to reset before another code entry attempt is possible.
Code Entry as Follows:
If Required, Enter Code in Head Unit First.
Press And Hold " CD.C" Button
The Display Shows "CD Player" Then "0000"
Press preset " 1 " repeatedly for 1st Digit
Press preset " 2 " repeatedly for 2nd Digit
Press preset " 3 " repeatedly for 3rd Digit
Press preset " 4 " repeatedly for 4th Digit
If the correct code number is now shown
Press Tuning Up Button " ^ " To Enter