Proizvođač -grundig
Model -stf 72-1010/7 text
Model chassis -gbf2500 ctv100
PCB Nr -
Procesor -stv3500
Eeprom -24c64
Vertikala -
Video -
Audio -
SMPS -
Display-ekran -a68
FBT(VN trafo) -
Tuner -
Opis kvara i opis poduzetih radnji i merenja na aparatu -
Potreban ulazak u SM .
[ODUSTAO] grundig stf72-1010/7 text
-
Admin Jimmy
- Administrator
- Postovi: 3903
- Pridružen/a: 28 sij 2012 18:56
- Been thanked: 1 time
Treba ti servisni daljinski upravljać
http://elektrotanya.com/grundig_stf_72- ... nload.html
Chassis Adjustment:
General description of method to enter into SERVICE MENU and ADJUST MENU:
- Turn on the Main Power Switch, then press “FACTORY” key about 3 seconds on the handset (service remote unit, please refer to the attached drawing).
The “HPS ----------- Geometry Adjust” will be displayed on the screen: When receiving signal is 50Hz, the “100i” will be displayed under the
“Geometry Adjust”, otherwise, when receiving the 60Hz signal, the “60P” will be displayed instead of “100i”.
- Use volume “+” and “-” keys to adjust the parameter.
- Pressing channel “P+” and “P-” key select other items;
- On Geometry Adjust mode, refer to the follow table 1 to find adjustment items.
- Press “FACTORY” KEY again, The “RCUT -----------White Balance” will be displayed on the screen:
- On White Balance mode, refer to the follow table1 to find adjustment items.
- Repeat the above step and
- press “FACTORY” KEY to exit the adjustment menu.
http://elektrotanya.com/grundig_stf_72- ... nload.html
Chassis Adjustment:
General description of method to enter into SERVICE MENU and ADJUST MENU:
- Turn on the Main Power Switch, then press “FACTORY” key about 3 seconds on the handset (service remote unit, please refer to the attached drawing).
The “HPS ----------- Geometry Adjust” will be displayed on the screen: When receiving signal is 50Hz, the “100i” will be displayed under the
“Geometry Adjust”, otherwise, when receiving the 60Hz signal, the “60P” will be displayed instead of “100i”.
- Use volume “+” and “-” keys to adjust the parameter.
- Pressing channel “P+” and “P-” key select other items;
- On Geometry Adjust mode, refer to the follow table 1 to find adjustment items.
- Press “FACTORY” KEY again, The “RCUT -----------White Balance” will be displayed on the screen:
- On White Balance mode, refer to the follow table1 to find adjustment items.
- Repeat the above step and
- press “FACTORY” KEY to exit the adjustment menu.
-
mcatko
- Expert
- Postovi: 277
- Pridružen/a: 18 tra 2012 10:46
I ja sam to citao ,ali sam mislio da nema kakva caka .